6 ft./72 in. Black Steel Bent Strap Sliding Barn Door Track and Hardware Kit with 12 in. Cylinder Handle and Floor Guide

Description

This sliding door hardware is made of high quality steel in high temperature fine black powder coated surface ensures anti-corrosion and years of beauty and longevity. The modern twist on the classic barn door not only saves space, it allows the ability to open up multiple rooms. Suitable for indoor decoration in kitchen, bedroom, dressing room, club, pub and so on. Waterproof and rust resistant tract kit also a nice door accessory for barns, garages, stables, etc. Comes with 12 in. Black Powdered Pull and Flush Sliding Barn Door Handle.

• High strength industrial grade tracks and pulleys can easily hold 350 lbs. loads
• Great for doors 1-3/8 in. – 1-3/4 in. thickness
• Sturdy nylon wheel: superior quality bearing and upgrade design make it slide smooth and quiet
• Door stop: doorstops on the track ends prevent the pulley from rolling off the track, doorstops can be located freely along the track according to your needs
• Floor guide: fit door panel thickness: 7/8 in. to 2-1/8 in., adjust the 2 rollers to fit the door panel and then tighten the screw in the bottom of the floor guide so that the rollers will be fixed in the workable position
• Anti-jumpers: go on top of the door and won’t allow door to be lifted off rail unless they’re turned
• Ordinary screws are used for wood walls and cabinets
• 12 in. black sliding door handle: high quality steel and frosted black surface, chamfered edge ergonomically design prevent any unexpected injury and provide a more comfortable handing feeling
• Package included: barn door hardware kit, (1 x 6 ft. rails, 2 x J-shape hanger, 4 x rail spacer, 1 x 12 in. square pull handle set, 1 x single roller floor guide, 1 x T-shaped floor guide, 2 x door stop, 2 x end cap, 1 x hex key) all assembly hardware is included as you see in the pictures, door not included
• Pre-install notice: only the hardware is for sale, doors are not included, the hardware package has lag bolts for wooden wall, our sliding barn door hardware kit is compatible with door thickness from 1-3/8 in. to 1-3/4 in. if you have a door trim, you would better put a header board that is as thick as the trim and then attach the rail to the header board, you need to have at least 8 in. of space between the top of the door to the ceiling to accommodate the hardware, we use two hangers to hold one door, for a single door kit, there will be two hangers in the package, for a double door kit, there will be four hangers, if you have a door that is either too wide or too heavy, then you can purchase additional hangers for that door

Features

New Bath